Unknown Suppressors OG Experience

[MTLabrador]

Guess I'm an idiot. mtmuley

So am I. I can’t take 350 pages of punching myself in the dick.

 

[mtmuley]

So am I. I can’t take 350 pages of punching myself in the dick.

Yep. Get it now. mtmuley

 

[mtmuley]

I am pretty sure most members on RS like punching each other. mtmuley

 

[Deez Nutz]

There is a huge amount of useful information available on rokslide, there are also some Neanderthal hooligans, just like here.

 

[brockel]

There is a huge amount of useful information available on rokslide, there are also some Neanderthal hooligans, just like here.

More and more everyday here

 

[Wind Gypsy]

Well, I just placed an order for an OG Six-Five. The fact that it only adds 7.5 oz and 4” to the length of the rifle while also providing (by most accounts) pretty solid suppression finally won me over. That and I found a local shop that would do the transfer for $40.

Maybe it’s silly to get such a specialized can for my first suppressor, but I think it’ll be awesome for hunting and like The Troll alluded to—it likely won’t be my last.

Shot mine today on a 18" 6 creed and a 22" SAUM. Seems to suppress about like they say it should, should be a good can for you.

I did have some issues with the threading on/off getting sticky. Have read that can be an issue with ti dust on new 3d printed cans but hadn't experienced prior. Will fill you in more once I dig into and diagnose it better.

The nomad xc does seem a bit quieter but its not huge and not something you'd think about unless shooting them back to back.

Edit: rokslide fellas say the ti dust deal is normal. Should resolve with a cleaning of the threads. One recommendation was to use grease to get it on/off then spray with a degreaser to get everything cleaned off. Kind of a PITA, would be nice if that wasn’t a thing but should be a one time effort and hopefully good to go after.

 

[rtraverdavis]

Shot mine today on a 18" 6 creed and a 22" SAUM. Seems to suppress about like they say it should, should be a good can for you.

I did have some issues with the threading on/off getting sticky. Have read that can be an issue with ti dust on new 3d printed cans but hadn't experienced prior. Will fill you in more once I dig into and diagnose it better.

The nomad xc does seem a bit quieter but its not huge and not something you'd think about unless shooting them back to back.

Thanks for the update!