GPS Settings?

[RobertR]

I have an Oregon 450 with the land owner sd card.

My problem is that I don't know the the setting to make it show the roads or what needs enabled or disabled or if I need to down load something.

 

[gman82001]

Id say make sure your card is in properly because as soon as mine was in and fired up it showed everything

 

[Wapiti Warrior]

I had the same problem and found my gps was on the marine setting. It would show everything except the roads. I reset my gps back to factory settings and poof there were the roads. I have since modified some of the settings but still have the roads.

Not sure if this is your issue?

John

 

[pointingdogsrule]

On the Oregon 350 you need to set the "detail" on MOST.

1. push "setup"
2. push "map"
3. push "advanced map setup"
4. push "detail"
5. push "most"

This setting will give you roads & landowners names.

good luck to all
the dog