archerynut21
Active member
- Joined
- Jan 5, 2020
- Messages
- 105
Does anyone have any load data for the 124 grain Hammer Hunters in a 270 Win?
270 Win Hammer Bullets load data
- Thread starter archerynut21
- Start date
stevejfarms
Well-known member
There is a very comprehensive, up to date list of hammer load data over on the long range hunting site
stevejfarms
Well-known member
Will 1-10” spin it?
I believe that's why Steve cut the bullet. Heavier than the 117, but stable in a 10 twist. mtmuley
stevejfarms
Well-known member
SixPoint
Active member
Has anyone played with the 124 HH yet?
D
Deleted member 20812
Guest
Looking at Nosler load data, I’d start with H4831 or H4350
SixPoint
Active member
I’ve been on the hunt for H4350 to no avail. I have some IMR4831 and was thinking of starting at 55gr. Does that seem reasonable? I’m very green at reloading so any thoughts are very appreciated.
SixPoint
Active member
Unfortunately I don’t. I noticed it referenced on the hammer forum as well as the H4350. Have you had good luck with it?
D
Deleted member 20812
Guest
I haven’t used IMR 4831, but I believe it’s a fair bit faster burning than H4831. I would probably start lower.
SixPoint
Active member
Awesome. Thanks for the advice guys!
I've been working up a load with the 124 HH's. Not the most popular powder, but I've found a good combo with the following:
Browning X-Bolt Pro 1-10 twist
Norma URP 59.6gr @ 3330 fps
Hornady brass
CCI 200 primer
.020 off lands
60.8 gr is where I found pressure
Sub 1 inch from a rifle that I have been considering throwing a new barrel on because it's just awful. Very disappointed in Browning.
Tried Reloder 19 but no where near the velocity I wanted before running into compressed loads. I would definitely stick with that 4350 burn rate.
Browning X-Bolt Pro 1-10 twist
Norma URP 59.6gr @ 3330 fps
Hornady brass
CCI 200 primer
.020 off lands
60.8 gr is where I found pressure
Sub 1 inch from a rifle that I have been considering throwing a new barrel on because it's just awful. Very disappointed in Browning.
Tried Reloder 19 but no where near the velocity I wanted before running into compressed loads. I would definitely stick with that 4350 burn rate.
Similar threads
