Muzzleloader Safety

A few things, since I'm not that well versed in this topic, but very interested in building a traditional cap & ball some day.

Laramy "Sasquatch" Miller- lost a finger to a muzzleloader accident. Kept the gun loaded, with a cap on for moisture prevention, but carried it by the barrel over his shoulder. Hammer caught on some brush, released & fired, and he lost a finger. Could have gone much worse. Because of that little story, I wouldn't carry with a cap on a traditional ML due to the danger of a negligent discharge. I have carried a modern in-line on half-@#)(# with a primer seated, though, since the primer is held in place even at half-@#)(#.

If you fire your traditional ML each night, do you need to disassemble and clean it immediately before reloading for the next day? I thought the spent powder would cause corrosion in the bore pretty quick. And a corroded bore is nearly useless. Not sure what the daily care routine should look like for one of these.
 
If you fire your traditional ML each night, do you need to disassemble and clean it immediately before reloading for the next day? I thought the spent powder would cause corrosion in the bore pretty quick. And a corroded bore is nearly useless. Not sure what the daily care routine should look like for one of these.
Absolutely.
 
Good in depth look at leaving BH209 in for extended period


May have done a similar test myself as I leave mine loaded for the season here. One of those were I thought I was going to go back out hunting but never did, then realized I needed to shoot to unload it but didn't have a convenient time. Ended up being quite a while... many months, shot went off like normal and hit where I was aiming.

Limited muzzleloading experience myself. Had one for 3 years and have only shot one deer with it. CVA Wolf with BH209.

One safety tip if you do plan on leaving powder/bullet in is make sure you do not double load your muzzleloader. I marked on my ramrod the height I should be at with powder and bullet in as an additional safety.

Anyone have experience on shelf life of an open can of BH209, and shelf life in the tubes?
 
Last edited:
If you fire your traditional ML each night, do you need to disassemble and clean it immediately before reloading for the next day? I thought the spent powder would cause corrosion in the bore pretty quick. And a corroded bore is nearly useless.

1000%. Anyone who says leaving a muzzleloader fouled probably cannot see well enough to observe the damage happening to the bore and breech plug.

What do you do when you need to get back in the truck or its end of the day of the hunt but are going out again in the morning?

I did an experiment this year, just so I'd have first hand eyes on instead of reading what the internet experts have to say. Loaded my rifle- CVA Wolf with 777- for the last weekend of Florida's blackpowder deer season, in February of 2026. Hunted with it, to include paddling about 6 miles through a swamp on a kayak. Left it. Moved across the US back to the mid Atlantic. Pulled it out in mid October, put one of the primers that had been living in the screw hole of the buttstock in. Bang. Immediate ignition, impact dead on.

Even if you hunt in humid environments or wet conditions, you'll probably be just fine leaving it loaded all season. I personally replace the charge if I've been out in a downpour, but that's just insurance more than anything.

Screenshot_20261029_152129_Gallery.jpg

Screenshot_20261029_152013_Gallery.jpg
 
worth checking your state's definition of "unloaded" too. in colorado it just means no cap on, but it's not the same everywhere, good luck on the elk
 

Forum statistics

Threads
120,333
Messages
2,256,699
Members
39,123
Latest member
Bbeck54
Back
Top