Recent content by eoperator
-
E
Remington 17hmr accutips
Cci federal hornady and remington 17hmr are all made by cci.- eoperator
- Post #2
- Forum: Ammunition and Reloading
-
E
NFA Wait Times
I had an empty feeling knowing I was not not waiting on the atf so the only sensible thing to do was submit another.😁 -
E
243 and H1000
Not 243/h1000 but my 6cm/n565-108eldm is very consistent and low es but compressed.- eoperator
- Post #22
- Forum: Ammunition and Reloading
-
E
6mm 95gr & 7mm 160g sierra tmk's
I have 2 rifles that love tipped match kings but it seems nearly impossible to find any more. Anyone that has extra, or a lead to find some? thank you, mark- eoperator
- Thread
- Replies: 0
- Forum: Want To Buy
-
E
Neck tensioning sequence
I rarely - anneal, clean, deburr flash hole, use expander mandrel, never turn necks, adjust powder charge 0.1 grain, adjust seating depth 0.003, change primers or do 21 trick plays while reloading. I use quality - full length dies(with button), press, SCALE(a&d 120), brass, powder and bullets...- eoperator
- Post #33
- Forum: Ammunition and Reloading
-
E
To crimp or not to crimp?
I went through a phase that I felt everything needed to be crimped. In my experience crimping (normal hunting calibers) does change things, sometimes better, sometimes worse, sometimes without change and not always repeatable. I found one load with hammer bullets that seemed to cut the group...- eoperator
- Post #21
- Forum: Ammunition and Reloading
-
E
Honest, down to reason Opinions request...
Seekins element, 6.o lb long action. Or build your own defiance anti, pre fit barrel and stock or chassis of your preferred flavor. -
E
Poll: Rifle Caliber for Western Hunting
I would pick a middle ground 280ai, eldm, or eldx will run toe to toe with the 6.5prc with less wind drift and more energy and an extra 1 or 2 fit in the magazine. I had a 24" cf barrel with brake that is being replaced with a 20" and suppressor for the same reasons as you. Buy an action that...
