Bhoesl's latest activity
-
Bhoesl replied to the thread Tarp over wall tent.I used a tent with an attached floor once and didn’t care for it. I had borrowed the tent from a relative so I was extra worried about... -
If you set a wall tent up nice and tight it will no longer be tight after rain or snow. The tent will sag before the eave and water will...
-
If you do it right it could pay off.😂
-
Bhoesl replied to the thread Tarp over wall tent.Thanks everyone. Sounds like I will plan to just run the tarp directly over the ridge and try to tie it out to leave a gap along the...
-
Same here
-
Just pass the tarp directly over the ridge pole. If you maintain an air gap for everything else, you will get 99% of the benefit for...
-
We have always just put the tarp directly over the tent. I think it might depend on the heat source because propane will emit a lot of...
-
Bhoesl replied to the thread Tarp over wall tent.I understand about condensation. I guess maybe I didn’t explain my question properly. I definitely plan to keep the tarp tied off...
-
Bhoesl replied to the thread Clutch replacement.Nope, and definitely not trying to. But I am saving a lot of money and learning along the way. Thanks again for all your help and advice!
-
Bhoesl replied to the thread Clutch replacement.Thanks again to everyone's help, the transmission went back in pretty smoothly. Now onto the transfer case, driveshafts, and exhaust...
-
For those of you who use a tarp over top of your wall tent, do you put the tarp directly over the canvas at the top, or do you rig up...
-
I think having a standardized interchangeable battery system will be paramount to charging stations. People driving long distances...
-
Yeah, don't let it sit on the tranny jack while you go eat lunch. They have a tendency to bleed off.
-
Bhoesl replied to the thread Clutch replacement.Yes, the alignment tool will slide in and out easily. I also cut the heads off a couple 3/8 bolts and rounded off the ends to use for...
-
Bhoesl replied to the thread Clutch replacement.The flywheel and clutch are back in. Also changed out a couple of seals on the transfer case and the pinion seal on the front diff...
-
