Does a fired case chamber? Does it chamber after FL re-sizing? I would think that would eliminate the FL die as the source of the problem. Try cleaning the FL die by putting an oversize patch or piece of TP in a needle eye jag and squirt a tad of Ronsonol on it.
You may have the seating die screwed down too far to where the case mouth is hitting the crimp feature built into the die. Instead of crimping you are pushing the case down to where it bulges enough [probably at the case body shoulder junction] and won't chamber.
Interest rates aren't going to drop like a rock so if you have a large amount of cash drawing 5% or so after the first decrease you may want to look for a vehicle to lock in current rates for the next few years at least. I have one IRA where the interest earned approximately equals the RMD. For...
It's only a .22 with little recoil so not sure why you'd want to pair the lightest base with the heaviest rings. A good quality aluminum ring should work fine. If you're stripping the threads in the screw holes of the ring half then you're obviously doing something wrong.
I have a couple older Forster hand trimmers that work fine. I'd set a new factory case aside to use as a reference to reset the trimmer if you do cases of different lengths. In general Ackley Improved cartridge cases seem like they'll never need trimming. Not sure about the .280AI as it's...
Did you strip the screw or the receptacle hole in the ring half? You might try new screws first if you can find them locally. If it's in the ring half yer screwed. Or if they are Allen head screws I'd buy rings that fasten together with Torx screws.
Bubba and Billy Joe were on vacation, walking downtown, window shopping, and
they see a sign on a store that reads, "Suits $5.99 each, shirts $1.99 each, trousers $2.49 each.
Bubba says to his pal, "Billy Joe, Look here ! We could buy a whole gob of these, take 'm back to Alabama, sell 'em and...
How can they tax unrealized gains? Seems like they should have been able to deduct/subtract any cost of improvements plus interest if the money was borrowed. There has to be attached forms showing where the gains came from.
I have available 1000 Winchester large rifle primers and 2000 Federal large rifle match 210 M primers recent manufacture. Asking $350 cash firm for all 3000. Meet F2F in Ames, Iowa, area as I can't/won't ship. If you will be passing through the area and decide you want them I would ask for a $25...