grizzly63's latest activity
-
Ggrizzly63 replied to the thread Ethics of removing tree stands from public land.In South Dakota, they have had auctions to sell off all the confiscated tree stands, dead heads, illegal kills, empty brass, LE firearms...
-
G#1 CFE-223 #2 IMR-4895 #3 H-4895 This is from QuickLoad, but based on burn rates these would be my choices. YMMV. Always work up loads...
-
Ggrizzly63 replied to the thread Ethics of removing tree stands from public land.Hey I drive one of those monsters. Only stranded me twice during deer season.
-
Ggrizzly63 replied to the thread New hunting rifle addition.I got a "New" Burris Fullfield 2 6.5 x 20 for $117 delivered this week. Like the ballistic mil dot duplex. Got lucky on Ebay. Made a...
-
Ggrizzly63 reacted to NEWHunter's post in the thread Ethics of removing tree stands from public land with
Like.
Take them down and leave them at the base of the tree. If they’re still there after this deer season then keep them. -
Ggrizzly63 replied to the thread Honda Trail 90.I had a Big Tire 200 Yamaha. It would climb decently but didn't like ice after too many folks packed the roads down. I think the Rokon...
-
Ggrizzly63 reacted to Elkmagnet's post in the thread Who panics and presses that little orange button the most? with Like.
Friend of a friend had spent most of a day belly crawling into position on an animal when a helicopter showed up. He was surprised to...
-
Ggrizzly63 replied to the thread Ethics of removing tree stands from public land.You cannot install permanent stands on public ground around here. A few years back I went thru the local hot spot and removed all the...
-
Ggrizzly63 replied to the thread Off-season project - 7mm Rem Mag.I use one of the those old Pacific presses and sometimes think maybe I should upgrade but if I'm making ammo that generates sub moa...
-
GArchery Talk forums used to have a good classified section. I’ve bought and sold there. I haven’t been on that site in years though.
-
GYup I'm still alive and kicking. 😉
-
Ggrizzly63 replied to the thread Axle to Axle Advantages?."Well for better or worse I bought a new bow and I'm going to gift my old one to my buddy who is trying to get into Archery. He is a...
-
Ggrizzly63 reacted to Mallardsx2's post in the thread Broken drill bit removal in rifle stock with Like.
Plasma cutter. For sure.
-
Ggrizzly63 replied to the thread Broken drill bit removal in rifle stock.You could also take a small pin punch and line up with a groove in the bit to try to tap it counterclockwise which may make it free up...
-
Ggrizzly63 replied to the thread Broken drill bit removal in rifle stock.Put a small amount of JB weld on the other end of that broken bit and try to weld it to the broke section. Put tape or some kind of...
