Also for tuning everyone has their own process so there's no rule on whats right or wrong since all the different methods get to the same spot. For me at least I'll run through these steps.
Verify draw stops on the cams are hitting at the same exact time or maybe the top just before. Verify...
for arrows measure carbon to carbon. actually not too bad assuming youre not running brass inserts and if you cant get it tuned could drop to 100gr heads and/or cut the arrow down a little from there to stiffen it up. if you plan on going up from 60# go up in spine but you and your bow just...
probably not the best but bahco laplander has the right price, doesnt weigh a ton and can do anything saws of its size should. silkys are also well regarded
Got a powerwagon after my tacoma blew an engine at 180k last fall. The ride is car-like with those soft coils and imo softer than the tundras we tried. The other trims were stiffer but still soft compared to a leaf sprung truck. Semi loyal to toyota but if youre towing or need more creature...
You can buy as you need from most used/cheap to least used/expensive. IMO in order: basic hand tools, arrow level, fletching jig, arrow saw, bow vise, bow press, diy draw board and serving jig. For top quality stuff, all in well under $1k. For me it took piecing together for over ten years and...
my only experience has been with tacomas and 4runners. at least with these anything under 2" is fine. anything over and start having to run spacers/offset wheels to not rub on the upper control arm and probably recommended to get aftermarket upper control arms to correct the alignment issues. on...
I do see one unit for sheep that a NR drew last three years. Still lowest odds and after a couple years of sub 1% the NRs will filter off to other areas with better odds too.
Is there any way to guess if a specific unit will have a non-resident tag in Idaho? For example lets say a unit has ten tags available. For three years in a row they gave nine to residents and one to a non-resident but last year they gave all ten to residents. Is there any publication or...
My process has been to break the pack down into smallest separate components possible. Hand wash in bath tub with warm water and half a scoop of green lid oxi clean(unscented, no bleach) then empty tub, refill with fresh water, hand wash and repeat until water runs clear. Usually takes 15-30...