I had a lot of issues with this before going to the K&M Neck tool. A lot of tools do the VLD cut, but the K&M tool does the best job hand down. You can set your depth and the built-in stops will make sure you are cutting consistently. Also, if you are looking at new presses I'd consider the...
1. No - I run a Redding T7, Frankford M-Press and Hornady L&L so I don't remove dies.
2. No - Imperial Sizing Wax on the outside, never needed it on the inside of the case when using a Redding Type-S bushing Die.
3. I use a Lee Auto Bench Prime and never run in to issues.
Hello all,
I have a buddy trying to sell his once used Mystery Ranch Metcalf. We went on a scouting trip last year and his job ended up preventing him from getting out and hunting. Has never hauled any meat or even been in load haul mode, he keeps it in a tote and couldn't have had more than...
Best of luck in finding the right boot. I ordered the Lathrop & Sons High Country Synergy insoles for my Tibet’s. The included insoles feel fine but I’ve read nothing but great reviews on the synergy insoles so I figured why not give them a shot.
Weight alone is not the primary concern in stabilizing a bullet. A 1:8 twist will barely stabilize a 124 gr Hammer because of the length of the projectile. Below about 700’ elevation it ain’t happening in cooler temps.
Granted most hunting is done well about that elevation, I’d be cautious in...